The internal principle of the MEMS gyroscope is as follows: apply voltage to the fixed finger and alternately change the voltage, let a mass move back and forth in an oscillating manner. When rotating, the Coriolis acceleration will be generated, and then it can be measured. This is a bit like an accelerometer, and the decoding method is roughly the same, and the amplifier is used. The angular rate is determined by the Coriolis acceleration measurement
– Coriolis acceleration = 2 × (w × mass speed)
– w is the angular rate applied (w = 2 πf)
Fast coupling to the accelerometer frame through the speed (periodic motion) applied by the 14 kHz resonant structure
– Coriolis acceleration has the same frequency and phase as the resonator, so it can cancel low-speed external vibration
The mechanical system is similar in structure to accelerometers (micromachined polysilicon)
Signal conditioning (voltage conversion offset) uses techniques similar to accelerometers
A varying voltage is applied to move the device back and forth, at which point the device has only horizontal motion and no vertical motion. If a rotation is applied, it can be seen that the device will move up and down, and the external finger will sense the motion so that the rotation-related signal can be picked up.
If you want to get more details about MEMS Gyro,pls visit https://www.ericcointernational.com/gyroscope/mems-gyroscope/